Taylor-Dunn B0-248-36, Service Replacement Parts

Page: 87 / 158

Suspension
Page 87 MB-248-18
B0-248; B0-254; BT-248; BT-280 (36v & 48v)
REPLACE THE SHOCKS
It is recommended to replace all shocks as a set.
Note: On some vehicles it may be required to remove the front wheel to gain access to the shock mounting
bolts. Refer to Tires and Wheels section for information regarding removing the front wheels.
6: Some vehicles may require that the wheels be lifted off of the ground and supported with jack stands to
replace the shocks.
7: Remove the upper and lower shock bolts.
8: Remove the shock from the vehicle.
Note: If the shock that was removed is to be reinstalled:
a. Inspect the shaft where it enters the shock body for any signs of leakage. If any sign of leakage is seen,
then the shock must be replaced.
b. Inspect the upper and lower shock bushings. If any signs of damage or wear are seen, then the shock must
be replaced.
9: Install the shock in reverse order.
10: Lower the vehicle.
11: Reconnect the main positive and negative cables at the batteries.
12: Remove the blocks from behind the wheels.
13: Release the parking brake and test drive the vehicle.
Always use a lifting strap, hoist, and jack stands, of adequate capacity to lift and support the vehicle. Failure
to use lifting and support devices of rated load capacity may result in severe bodily injury.
1) Make sure the key-switch is in the “OFF” position, then remove the key.
2) Place the forward-reverse switch in the center “OFF” position.
3) Set the park brake.
4) Place blocks under the front wheels to prevent vehicle movement.
5) Disconnect the main positive and negative cables at the batteries.
HARDWARE TORQUE
If hardware is not listed here, refer to standard torque
values in the appendix.
Description Foot Pounds Newton Meters
Spring Hanger Bolts 20 27
WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.