Taylor-Dunn B0-248-36, Operation, T Roubleshooting And Replacement Parts Manual

Page: 149 / 292

Maintenance, Service, and Repair
Batteries Page 5
WATERING
NOTE: The electrolyte level in a battery rises while charging and will be
close to its highest level after the end of a charging cycle. It is
recommended to fill the batteries at the end of a charging cycle. If
the electrolyte is below the top of the battery plates then fill just
enough to cover the plates and then top off when the charging
cycle is complete.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
A battery is a live electrical source. It cannot be disconnected or
neutralized. Do not drop any tool or conductive object onto the battery.
A conductive object that comes in contact with the battery terminals
will initiate a short circuit of the battery. This could cause the battery
to explode resulting in severe bodily injury and/or property damage.
Battery electrolyte is poisonous and dangerous. It contains sulfuric
acid. Avoid contact with skin eyes or clothing. Wear rubber gloves
and safety glasses while servicing batteries. DO NOT INGEST! This
may result in severe bodily injury.
Explosive mixtures of Hydrogen gas are present within battery cells
at all times. Do not work with or charge battery in an area where
open flames (including gas furnace or water heater pilots), sparks,
cigarettes, or any other sources of combustion are present. Always
provide ample ventilation in rooms where batteries are being charged.
Failure to do so may result in severe bodily injury and/or property
damage.
Do not overfill the batteries. Over filling the batteries may cause the
batteries to boil over and result in severe bodily injury or property
damage.