INSTALLATION MANUAL TX80 SKYGLASS
INTERFACOM, S.A.U.
Inst TX80_Skyglass_003_en.doc
17
7.3. SEALING (Drawing 11)
−
The pulse generator installation can also be sealed, as shown in the image.
7.4. TECHNICAL CHARACTERISTICS
−
The main technical characteristics of the pulse generator are:
−
Sensor type:
Hall effect cell
−
Number of pulses / revolution:
4 with double impulses train
−
Feeding voltage:
4 to 18 V
−
Consumption at 5 V:
10 mA
8. VEHICLES WITH ELECTRONIC IMPULSE SIGNAL
-
The distance signal supplied by the car can be connected in two possible ways:
-
By connecting this signal to the Green/White wire on the Power Supply cable
-
By using the dedicated impulse generator connector, with a shielded cable, or even
mechanical shield, according to local regulations.
- The adaptation of the signals of the different vehicles is done by an internal electronic
circuit with the following characteristics:
•
Histheresys of the input is configurable
•
It adapts to different levels
•
Optional Pull
–up
•
Optional Pull
–down
•
Constante K is adjustable between 500 and 80000 km-1.
- All these adjustments are done from the tariff changer. It is necessary to unseal the
device.
