Taurus TF-RUN-X-2, Assembly And Operating Instructions Manual, Page: 19 / 36

RUN X
19
3.5 End programme - stop mode
To end the programme, press the STOP button once.
+ While pressing, a signal sounds for 0.5 seconds and the console enters stop mode.
After 0.5 seconds, the display will first show the DISTANCE, TIME and CALORIES values of the
training session (Fig. 7).
+ After 7 seconds a short beep sounds and the maximum values of the training session for WATT,
SPEED and PULSE are shown on the display (fig. 8).
+ After 7 seconds a short beep sounds and the average values of the training session for WATT,
SPEED and PACE are shown on the display (fig. 9).
L
NOTICE
The values are displayed three times in total, after which the console goes into standby mode.
Fig. 7 Fig. 8 Fig. 9