26
3.4.3 Tool change
1. Switch the motor switch (2.3) to position OFF.
2.3
The message „Motor Off“ appears in the display.
Warning:
The motor switch (2.3) has to be on position OFF because the drive
spindle can start running.
Warning:
Tools are sharp and can cause injuries.
A
A1
A2
B
B2
B3
B1
C
C1
C2
Fig.: 3.13
2. Unclamp tool (C)
•
Hold the quick change insert (B) with one hand and pull up the pressure cover (A1).
The quick change insert will be unclamped in this way.
•
Press the spring dowel pin (B1) of the quick change insert (B) and remove the thread
tool. (C).
3. Insert tool (C)
•
Insert the thread tool (C) into the quick change insert (B).
The square (C1) of the thread tool has to snap in the square (B2) of the quick change
insert (B).
•
Plug the quick change insert (B) in the quick change holder (A).
The nose (B3) has to snap in the nut (A2). By doing this the pressure cover slips
down and clamps the quick change insert (B).
4. Switch back the motor switch (2.3) to the position ON.
2.3
