1. Insert 3AA batteries in rear compartment of Receiver and 1 9V battery in rear compartment of Sensor.
2. Volume Control. There 4 levels of sound (off, low, medium, loud) which is adjusted one level at a time
at (A) upper switch on side of Receiver.
3. Ring Tones. There are 32 ring tones, which are set at (B) lower part of switch on side of Receiver.
The ring tones may be changed one at a time by pressing the switch. The LED light (C) on the front of the
Receiver will flash when the ring tones are playing.
4. Screw Mounting Bracket into wall. Slide opposite end of ball-looking part into rear lower section (D) of Sensor.
Press ball into Mounting Bracket and adjust angle as needed. Note: The Sensor works at an angle of about
100 degrees and with a motion-detection range of about 20 feet. If sensor is detecting more movement than
you wish, cover part of Sensor with opaque tape or paper to narrow sensing angle.
5. Place Receiver where needed. Note that the fewer walls that separate the Sensor from the Receiver the longer
the distance that the Receiver can be placed. Over time, the batteries will weaken and may need to be replaced.
6. Adjust On/Off switch (E) on side of Sensor as needed.
INSTRUCTIONS FOR USE
E
D
C
A
B
RECEIVER
SENSOR