TATA Motors Nexon EV 2003, Owner'S Manual, Page: 230 / 308

Remove wheel nuts with the help of wheel
spanner and take out flat tyre.
Roll the spare wheel into position and align
the holes in the wheel studs.
Tighten each nut by hand until the wheel
is securely seated on the hub.
Lower the jack completely then tighten the
wheel nuts diagonally in opposite se-
quence one by one using wheel spanner.
Press fit the wheel cover back (if
equipped).
Restore all the tools and jack at their re-
spective locations.
Place the flat tyre at spare wheel location
PUNCTURE REPAIR KIT OPTION 1
(if equipped)
Introduction
The tire puncture repair kit seals most •
tire punctures to restore temporary
mobility.
Recommended to use only for passen-
•
ger car ground tubeless tires only and
vehicle tire inflation pressure up to
300kPa (3 bar /43psi).
The system consists of a compressor
•
and a sealant, and serves to effectively
and conveniently seal punctures in car
tires caused, for example, by nails or
similar foreign objects with a diameter
of up to ¼″ (6 mm).
Depending on the type and extent of
•
NOTE
Do not place wheel nuts in sand or on a
dirty surface. Do not apply oil or grease
on it.
NOTE
Do a check and correct the tyre •
pressure and wheel nuts tightness
of the changed wheel at nearest au-
thorised service station. Get the flat
tyre repaired at the earliest
Do not jack the vehicle under rear
•
axle.
WARNING
Compliance to below instructions is vital
to ensure vehicle safety and personal
safety. Non-compliance may result in
serious injury or death. Damage to tire
will affect vehicle handling and lead to
loss of overall vehicle control.
EMERGENCY AND BREAKDOWN
221