Taski swingo 455B, Manual

Page: 63 / 346

63
Open battery compartment for maintenance
Warning:
Before opening the battery compartment make sure
that both tank areas are empty.
Warning:
After maintenance, carefully bring the tank back to
its initial position and screw in the screw.
Prior to commissioning
Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Caution:
Do not use brushes which have reached their wear
limit. The wear limit is indicated by the length of the
red bristle. Do not use worn or contaminated pads.
Use original TASKI brushes only.
Failure to observe these instructions may result in inad
-
equate cleaning results or even floor damage.
Notice:
When the brush is down, gently moving the ma
-
chine back and forth can make the clutch easier to
engage.
Squeegee assembly
Filling the fresh water tank
Notice:
Max. permissible water temperature 60 °C/140 °F.
Diversey recommends using cold water, as hot wa
-
ter will adjust to the ground temperature as soon as
it comes into contact with the ground. Thus there
are no advantages to using hot water.
• The machine must be switched off.
• At the bottom left and right on the
front side of the machine you will find
the battery compartment release.
• Undo the screws.
• Carefully tip the tank backwards.
Now the battery can be maintained
according to the manufacturer's noti
-
fication.
• Position the tools under the tool unit.
• Switch the machine on.
• To do this, press the main switch but
-
ton (ON/OFF) for 3 seconds.
The display lights up briefly.
• Unlock the foot pedal and lower the
tool slowly.
• Briefly press the operating lever.
In this way the tool is centered and engaged.
• The machine must be switched off (main switch).
• Position the suction nozzle (2) below
the suction nozzle holder (1).
• Press the foot pedal down until the
suction nozzle holder engages.
• Attach the suction hose to the con
-
nector.
• The machine must be switched off (main switch).
• Open the tank lid.
• Fill the fresh water tank with water.
1
2
2
1