Taski swingo 4000, Instructions For Use Manual

Page: 92 / 437

90
Moving the machine (in the case of a defect)
Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Squeegee assembly
Filling the fresh water tank
Dosing:
Notice:
Generally, the machine should only be
moved in pairs.
Attention:
Due to the high weight, manual movement
of the machine is risky!
Missteps can lead to personal injury and
damage to the machine.
• Movement is only possible when the release button is
pressed. (See page 89)
Attention:
Do not use brushes which have reached
their wear limit. The wear limit is indicated
by the length of the red bristle. Do not use
worn or contaminated pads. Use original
TASKI brushes only. Failure to observe
these instructions may result in inade
-
quate cleaning results or even floor dam
-
age.
Attention:
Before using the machine, check the pad
drive holder for wear and defects.
Any pad drive holder that is not intact or
defective may spin off the machine while
working.
In the case of non-adherence there is a
risk of accidents.
• Position the tools under the brush unit.
• Press the Brush drive ON/OFF but
-
ton.
The brush unit will be lowered auto
-
matically; the tools will be engaged
and stopped.
Attention:
Check whether the brushes are engaged.
• The brush drive is activated by pressing the gas pedal.
• The machine must be switched off.
• Position the squeegee (2) below the
squeegee holder (1).
• Push the squeegee holder down
-
wards to latch onto the squeegee.
• Firmly attach both suction hoses to the sockets of the
squeegee.
Attention:
Max. permissible water temperature
60 °C/140 °F.
Diversey recommends using cold water
since hot water will adjust to the floor tem
-
perature as soon as it is in contact with the
floor. Thus there are no advantages to us
-
ing hot water.
• The machine must be switched off.
• Open the tank lid.
• Put the fresh water tank (Flextank) onto the provided fix
-
ture.
• Take the dosing cup from the fresh water tank (Flextank).
• Fill water into the fresh water tank
(Flextank).
The upper red marking indicates the
max. permissible filling level.
• Tilt the tank cover back to the original position.
Attention:
Wear gloves, goggles and appropriate
(protective) working clothes when han
-
dling chemical products!
Notice:
Use chemical products recommended by
Diversey only and always observe the
product information.
Caution:
Using unsuitable products (e.g. products
containing chlorine, acids or solvents) may
cause harm to health and severe damage
to the machine.
2
1