35
Prior to commissioning
Prepare carpet
Fill tank
Application technique
Beginning work with the machine
Transport over stairs
Notice:
Vacuum the carpet before working with the
carpet cleaning machine.
For visible stains, treat the carpet with a
TASKI stain remover. Please contact your
Diversey service partner for help.
• Spray a 10% solution across the entire surface with the
help of the spray device and spray lance; leave to work for
10-15 minutes.
• Release the locking head for the re
-
covery tank.
• Remove the recovery tank.
• Fill the fresh water tank with water,
max. 9 l at max. 40 °C.
• Observe the fill line.
• Replace the recovery tank. Ensure
that the tank latches correctly.
Machine
aquamat 10.1
Wet cleaning
Yes
Dry cleaning
No
Cleaning parquet and laminate
floors
No
• Press both switches.
• Begin in the furthest corner.
• Press the spray valve action lever.
The water is sprayed onto the carpet
and immediately sucked up again.
• Pull the extension cord towards you.
The slower you pull it, the more thor
-
ough the cleaning.
• Release the action lever for the spray
valve and suction approx. 10 cm fur
-
ther.
• Lift off the squeegee.
• Start a new strip. For this, the squee
-
gee should overlap a part of the pre
-
vious strip.
Continue working in this manner until
the entire surface is cleaned.
Notice:
To avoid water splashes:
Before disconnecting the spray hose, al
-
ways:
- Switch the pump switch to OFF.
- Operate the manual valve again in order
to reduce the pressure in the spray hose.
Notice:
The machine must only be transported
over stairs by two persons.
• Switch off the machine.
• Unplug the mains plug.
Attention:
Lifting the machine can be dangerous un
-
der any circumstances!
Stumbling may cause personal injuries or
machine damage.
Attention:
The attached accessories must be re
-
moved before lifting!
Attention:
Both the fresh water and the recovery tank
must be emptied completely before lifting
the machine.
EN
