©Copyright Task Force Tips LLC 2002-2020
4
LKB-100 September 17, 2020 Rev12
3.0 GENERAL INFORMATION
This manual describes nozzles calibrated at 100 psi (7 bar). Contact the factory for data specific to models that operate with metric flow
calibrations. Task Force Tips Twister and Bubble Cup nozzles are economical, lightweight, and dependable. Their rugged construction is
compatible with the use of fresh water as well as firefighting foam solutions. Other important operating features include:
• Quick-acting pattern control from straight stream to wide fog
• Quick-change rear valve seat
• TFT’s 5-year warranty and unsurpassed customer service
3.1 VARIOUS MODELS AND TERMS
Table 3.1
Figure 3.1
3.2 SPECIFICATIONS
Table 3.2
3.3 USE WITH SALT WATER
Use with salt water is permissible provided the equipment is thoroughly cleaned with fresh water after each use. The service life of the
equipment may be shortened due to the effects of corrosion, and is not covered under warranty.
SERIES
MODEL
STANDARD
COUPLING SIZE
GALLONAGE SETTINGS
(gpm @ 100 psi)
*C
TWISTER
3/4” GHT
10, 24
D
TWISTER or BUBBLE CUP
1.0” NH
10, 24
D
TWISTER or BUBBLE CUP
1.0” NH
10, 40
F
TWISTER or BUBBLE CUP
1-1/2” NH
20, 60
F
TWISTER or BUBBLE CUP
1-1/2” NH
20, 95
F
BUBBLE CUP
1-1/2” NH
95 Single Gallonage Only
*C series Twister is available in a tip-only nozzle configuration only.
D and F series Twister and Bubble Cups are available in tip-only, ball valve, or ball valve with pistol grip
configurations.
Maximum nozzle inlet pressure with
valve shut off*
Twister 300 psi
20 bar
Bubble Cup 300 psi
20 bar
Operating temperature of fluid
33 to 120°F
1 to 50°C
Storage temperature range of fluid
-40 to 150°F
-40 to 65°C
Materials used
Aluminum 6000 series hard anodized MIL 8625 class 3 type
2, stainless steel 300 series, nylon 6-6, nitrile rubber
*Consult factory for higher pressure applications
NOZZLE WITH VALVE
and PISTOL GRIP
TIP ONLY NOZZLE
COUPLING
RUBBER
GASKET
PISTOL
GRIP
STREAM
SHAPER
ON
FL
OW
CONTRO
L
OFF
NAME LABEL
NOZZLE WITH VALVE
