14
TASCAM DR-701D
3 – Preparation
Using USB bus power
Connect the unit to a computer using the included USB cable as
shown in the illustration.
Connect the included USB cable
micro-B USB plug
Computer
If the USB cable is connected while the unit is on or the unit
is turned on with the USB cable already connected, the
USB
SELECT
screen will appear. Choose between USB bus power
supply or computer connection on this screen.
Turn the DATA dial to select
BUS POWER
and press the DATA
dial to enable power supply from the USB port. The Home
Screen will appear.
NOTE
Power is supplied from the USB port if the USB cable is
connected to the unit even when it contains batteries (USB
bus power prioritized).
CAUTION
•
Depending on the USB bus power specifications of the
computer, this unit might not function when connected
to the computer by USB cable. In this case, use a TASCAM
PS-P515U AC adapter (sold separately) or batteries.
•
This unit does not support computer power conservation
and sleep functions. When powering the unit using the USB
bus power of a computer, always turn such functions off.
Turning the power on and off (putting
it in standby)
CAUTION
•
The unit enters standby mode if shut down when the unit
is operating on AC power supplied through a TASCAM
PS-P515U AC adapter (sold separately) or bus power
supplied from a computer USB port.
•
Turn down the volume of the monitoring system connected
to the unit before turning the unit on/off (standby).
•
Do not use headphones when turning the unit on/off
(standby). Loud noises could damage the speakers or harm
your hearing.
Turning the unit on
To start the unit when off (in standby), slide the HOLD/
switch toward
until "TASCAM DR-701D" (start-up screen)
appears on the display.
The Home Screen appears after the unit starts up.
Start-up Screen Home Screen
CAUTION
When the unit is started up for the first time (or when
the built-in clock is reset after being left unused without
batteries), the
DATE/TIME
screen appears before the
Start-up Screen so you can set the date and time.(see
“Setting the date and time” on page 15)
Turning the unit off (putting it in standby)
When on, slide the HOLD/
switch toward
.
The unit turns off (enters standby) after it completes its
shutdown process.
CAUTION
Always use the
HOLD/
button to turn the unit off (put it
in standby).
While the unit is on, do not remove the batteries, disconnect
the power cord when using a TASCAM PS-P515U AC adapter
(sold separately) or disconnect the USB cable when using
USB bus power. Doing so will cause all recordings, settings
and other data to be lost. Lost data and settings cannot be
restored.
Resume function
This unit has a resume function. When started up, the unit
locates to the position (time) where it was when turned off (put
in standby) previously.
After the unit is turned on, playback is possible from the
position (time) it was at when the 2/
7
button was pressed to
turn the unit off (put it in standby).
NOTE
This data is stored on the SD card. The resume function will
not work if the card is changed or formatted.