TASCAM DP-03SD
47
8 – Editing Tracks
CUT (remove part)
IN
OUT
IN
This function cuts (deletes) the audio data between the IN and
OUT points on the selected track, and shifts the remaining
recording after the OUT point forward to the IN point. Therefore,
the track becomes shorter.
The following parameters are used in this operation.
• CUT TRK (
1
to
8
,
1
/
2
,
3
/
4
,
5
/
6
,
7
/
8
,
1
-
8
,
ALL
)
• IN/OUT
SILENCE (part erase)
IN
OUT
IN
OUT
This function cuts (deletes) the audio data between the IN and
OUT points on the selected track, leaving silence between the IN
and OUT points, as though there had been no recording.
This operation does not change the length of the track.
The following parameters are used in this operation.
• SILENCE TRK (
1
to
8
,
1
/
2
,
3
/
4
,
5
/
6
,
7
/
8
,
1
-
8
)
• IN/OUT
TIP
Using this function, you can delete short noises, for example.
CLONE track (track duplication)
Use this function to duplicate a single track, a track pair or the
stereo master track on a different track or track pair. Each track is
copied entirely, so the IN/OUT/TO points have no effect.
The following parameters are used in this operation.
• SOURCE TRK (
1
to
8
,
1
/
2
,
3
/
4
,
5
/
6
,
7
/
8
,
1
-
8
,
MST
)
• DESTINATION TRK
NOTE
If you choose the same track for both the SOURCE TRK and
the DESTINATION TRK and press the
F2
(
EXEC
) button, the
Same
Track
message appears and the operation is not
executed.
CLEAN out (track erase)
Use this function to completely erase the selected track. This
erases the entire track, so the IN, OUT and TO points have no
effect.
The following parameter is used in this operation.
• CLEAN OUT TRK (
1
to
8
,
1
/
2
,
3
/
4
,
5
/
6
,
7
/
8
,
1
-
8
)
