1- Introduction
TASCAM CC-222SL
1
7 – Cassette operating
Dubbing to tape from the middle of a CD
The above procedure describes the playback and recording
from the start of a disc (or the start of a programmed play-
back list).
To record from a point other than the ones above:
1 Locate the disc to the point where the playback is to
start.
2 Press the disc
PAUSE
key to pause playback at the
point where the playback is to start.
3 If recording is to start at the beginning of the cas-
sette, make sure the cassette is stopped, otherwise,
locate the cassette to the appropriate position where
recording is to start, and enter record standby
mode.
Using the headphones with the
MONITOR
switch set
to
MIX
will help here.
4 Press the
DUB 2
key. Playback starts on the disc,
and recording starts on the cassette.
Recording tapes from the PHONO deck
To record from an external record deck connected through
the
RIAA PHONO
inputs:
1 Prepare for recording as described above (load a
tape, set the REV MODE, etc.).
2 Press the
MENU
key until the
PHONO > XXX
menu item is shown.
Turning the
MULTI DIAL
or pressing the
SKIP
keys
on the remote control to select either
TAPE
.
Press the
MULTI DIAL
or
ENTER
on the remote con-
trol unit.
3 Press the
PHONO
key. The
PhONO
indicator lights on
the display.
If the tape is currently in stop mode, the tape re-
winds, and the deck enters record standby mode
(about eight seconds from the start of the cassette,
to allow for leader tape).
If the tape deck is already in record standby mode,
it will remain in record standby mode.
4 Start playback of the record.
5 Start recording with either the
PLAY
or
PAUSE
key.
Press
STOP
(cassette deck) to stop the recording.
The
STOP
key is the only key which is enabled dur-
ing phono recording.
NOTE
It is not possible to perform phono recording as
described above under the following circumstances:
a tape is not loaded or the tape is write-protected (the
phono to tape function is disabled with no recordable
tape inserted), or the tape is not either stopped or in
record standby mode.
Only recording as described above is possible from
the
RIAA PHONO
sources to tape. Manual recording is
not possible.
Erasing tapes
Anything previously recorded on the tape will automatical-
ly be erased when you make a new recording on it. It can
also be erased by “recording” on it with the
INPUT
level
control set to “0”.
Other recording features
Recording silences between items
At least four seconds of silence must be recorded between
items on tape when using the search functions (see “Search
keys” below).
When recording, press and release either of the
REC
MUTE
keys (main or remote). With the tape moving, the
record source is muted for about four seconds (the display
record indicator flashes), and the deck then enters record
pause mode. Press
PAUSE
or
PLAY
to re-start recording.
If the
REC MUTE
key is pressed while the deck is in
record standby mode, four seconds of silence will be
recorded on the tape, and the deck will return to record
standby mode.
If the
REC MUTE
key is held and pressed for longer than
four seconds while recording is in progress, silence is
recorded on the tape while the key is held down. The deck
enters record standby mode when the key is released.
