1 – Introduction
18
TASCAM CC-222
MK
IV
4 – Disc operations
Repeat playback
The unit can repeat the whole of the disc, the current track
only, or an A–B portion set as described here. Selecting the
repeat mode is only possible using the remote control unit.
NOTE
You can use this mode with Single, Random, or
Program playback modes.
1 The unit should be in playback, standby or stop mode.
Press the
REPEAT
key so that the display shows
Repeat ON
(the
REPEAT
indicator lights).
To cancel repeat mode, press the
REPEAT
key again so that
the display shows
Repeat OFF
and the
REPEAT
indicator
goes out.
A to B repeat playback
You can set the points between which playback should loop.
1 While playing back, press the
A-B
key on the re-
mote control at the point where the loop is to start
(A-point).
The
REPEAT
indicator lights up and
A-B
indicator
blinks till the second point (B-point) is entered.
2 Press the
A-B
key again at the point where the loop
is to end (B-point).
NOTE
If the A and B points are too close together, A-B loop-
ing is not possible.
Playback jumps back to the first “A-point” and
continues to the second “B-point” and then returns
to the “A-point” again, repeating the loop.
Cancel the A-B repeat mode by pressing the
A-B
key, or
the
STOP
key. Both indicators will go out.
During playback, if the
A-B
key is pressed, the loop will be
canceled and playback will continue past the B-point.
NOTE
A-B repeat cannot be set when the specified section
spans more than one track, and cannot be used with
MP3 discs.
Intro check
You can skip through the first 10 seconds of all the tracks
on a CD to check the contents of the CD.
NOTE
This function is only available from the remote control
unit.
1 When stopped, in the Continuous (normal) mode,
press the
INTRO CHECK
key.
The first 10 seconds of each track on the disc will be
played back.
2 Press the
INTRO CHECK
key again or the
STOP
key
to stop this playback process.
NOTE
In Single or Random playback modes, with the disc
stopped, pressing the
INTRO CHECK
key cancels the
mode and returns to Continuous playback mode.
This function inserts a gap of about four seconds between
tracks on playback. This can be useful when recording to
tape, so that automatic searching can take place more easily
on tapes recorded from disc (see “Search keys” on page 33).
NOTE
This function is only possible using the remote
control unit.
Press the
AUTO SPACE
key when in playback, standby, or
stop mode, the
A.SPACE
indicator lights on the right side of
the display. Pressing the
AUTO SPACE
key again cancels
the mode and returns to normal playback.
The
STOP
key also cancels the mode and stops playback.
Auto spacing
