Tarana Wireless, Inc. ©2021. All rights reserved.
RN Installation Guide vIG_RN_CBRS_2021-08
—
15
Step 6.
Torque the body of the cord grip to 4.5
—
5.1 N-m (3.3
—
3.8 lb-ft).
Step 7.
Insert the grommet into the cord grip body chamfered end first. Then
screw the sealing nut onto the body and torque the sealing nut to 5.6
—
6.2 N-m (4.1- 4.6 lb-ft).
Properly terminate and test the Ethernet cable run before proceeding. This
should include power verification on all pins of the Ethernet cable using a PoE
tester.
Ensure the PoE injector is protected from the elements in a suitable enclosure
or installed indoors.
The total length of both Ethernet cables (CAT5e or higher) from
the customer’s
access point or switch to the PoE injector and from the PoE injector to the RN
must not exceed 100 m (328 feet).
Additional local electrical codes and ordinances may apply to grounding.
Compliance in this area is the responsibility of the installation company.
The PoE injector must be connected to a Gigabit Ethernet device (laptop, router,
switch, or access point) in order to function correctly. Other speeds (10/100
Mbps) are not supported.
