Tarana Wireless, Inc. ©2021. All rights reserved.
RN Installation Guide vIG_RN_CBRS_2021-08
—
12
Wall Mounting Installation
If a pole mount is not desired, the elevation bracket may be attached to a wall.
Use fasteners appropriate to the wall material. A load rating of 23 kg (50 lbs) is
recommended per fastener.
Step 1.
With the elevation tabs protruding away from the wall as shown, apply
fasteners at the corners of the bracket to attach to a flush surface (wall).
Do not modify or enlarge the screw holes as this will compromise the
corrosion protection of the finish.
Step 2.
Lower the partially-installed screws on the chassis bracket mounted to
the RN into the slots of the elevation tabs.
Step 3.
With the RN in place on the elevation bracket, tighten both the
partially-installed screws and the lower screws connecting the chassis
bracket to the elevation bracket.
Step 4.
Step 5.
Figure 6: Elevation Bracket Installation (Wall Mount)
