Tarana Wireless, Inc. ©2021. All rights reserved.
RN Installation Guide vIG_RN_CBRS_2021-08
—
11
Elevation Bracket Installation
The elevation bracket may be attached to a pole or wall.
Pole Mount Installation
The elevation bracket may be installed on poles that are a minimum of 38 mm
(1.40 in) to a maximum of 64 mm (2.40 in) outside diameter.
Step 1.
Route the opened worm gear clamps through the bracket. The serrated
surfaces of the bracket will be facing the pole and the clamps will go
around the pole.
Step 2.
Mount the bracket such that the elevation tabs are protruding away
from the pole. The vertical hanger slots should be on top and the
horizontal elevation slots should be on the bottom.
The band clamps should be torqued to 4.5
–
5.1 N-m (3.3
—
3.7 lb-ft). Do not
exceed torque range.
Step 3.
Lower the partially-installed screws on the chassis bracket mounted to
the RN into the vertical hanger slots.
Step 4.
With the RN in place on the elevation bracket, tighten all 4 screws
between the chassis bracket and the elevation bracket.
Tilt adjustment may be made from 20 degrees up to 5 degrees down.
Figure 5: Elevation Bracket Installation (Pole Mount)
