Date: Feb. 21, 2011
INSTRUCTION SHEET
SPECIFICATIONS
Toy:
Toy No.:
Part No.:
Trim Size:
Folded Size:
Type of Fold:
# colors:
Colors:
Paper Stock:
Paper Weight:
EDM No.:
TAPZ
T8156
0920
16.5” W x 11” H
8.2” W x 5.5” H
Fold into half (W & H)
One
Black
White Offset
70 lb.
001
Tapz™ challenges your rhythm and reflexes with flashing sequences of lights and music. Follow the beat as lights pulse down the console’s five different zones. When a light reaches the bottom, just tap the play mat in
front of the zone – the shockwaves you make control each game!
CONTENTS:
T8156
ThE REflEx GamE ThaT NEvER miSSES a BEaT!
Keep these instructions for future reference as they contain important information.
TM
7+
1-4
1 Tapz™ Console
5 Play Mat Segments
1 Play Mat Center Hub
Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local authority for recycling advice and facilities.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
((1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
• This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE:
Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.
X O I
On
Off
Tye Me
TROUBlEShOOTiNG
If you are unable to access the Game Menu…
Make sure the power switch is in the “On” position, not set to “Try Me” mode.
If the Tapz™ console fails to detect your tapping…
Make sure that the play mat is level and that each segment is completely plugged into the hub – there
should be no debris under any of the segments. Also make sure that the console’s 5 feet are sitting in the
5 recesses on the play mat segments. Refer to “Tips on Tapping” to make sure you are tapping correctly. If
this doesn’t work, the batteries may need to be replaced.
If the unit locks up…
Turn Tapz™ off then, after 10 seconds, turn it back on to reset the unit.
If the lights dim or the sounds become distorted…
Replace the batteries as described above.
© 2010 Mattel, Inc. All Rights Reserved. Mattel, Inc., 636 Girard Avenue, East Aurora, NY 14052 U.S.A. Consumer Relations 1(800) 524-8697. Retain this address
for future reference. Mattel U.K. Ltd., Vanwall Business Park, Maidenhead SL6 4UB. Helpline 01628 500303. Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen,
Nederland. Mattel Australia Pty., Ltd., Richmond, Victoria. 3121. Consumer Advisory Service - 1300 135 312. Mattel East Asia Ltd., Room 1106, South Tower, World
Finance Centre, Harbour City, Tsimshatsui, HK, China. Diimport & Diedarkan Oleh: Mattel SEA Ptd Ltd. (993532-P) Lot 13.5, Menara Lien Hoe, Persiaran Tropicana
Golf Country Resort, 47410 PJ. Tel:03-78803817, Fax:03-78803867.
T8156-0920
BaTTERY SafETY iNfORmaTiON
In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being charged (if designed to be removable).
• Rechargeable batteries are only to be charged under adult supervision (if designed to be removable).
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries inside may explode or leak.
OPENiNG ThE BOx
The Tapz™ console is held in place by 3 pins. Flip up the tab on each, rotate them 90 degrees and the pins will pop out.
After removing the console and the play mat components (5 triangular red segments and 1 round rubber hub), you can
DISCARD
the 2 lever assemblies attached to the package. They are included for demonstration
purposes only and are not needed to play the game.
ThE TaPZ™ CONSOlE
YOU CAN DISCARD THE TWO LEVERS
ATTACHED TO THE PACKAGE.
Bottom of Console
Menu Button
Light Zone
Play Mat
Power Switch
“X” - Try Me
“O” - Off
“I” - On
Battery Compartment
