TAPEPRO FLATBOX
- The Flat Box blade is not correctly adjusted.
- The coat is too thick.
- The coat is too thin.
Cause
Cause
Cause
TROUBLESHOOTING
Problem
Problem
Problem
- The Box is leaving edges.
- The joint compound has a pothole effect.
- The Box is leaving hollow joints.
Solution
Solution
Solution
- Check the Flatbox blade is set 1 – 1.5mm above the skids. This setting can be
done by tightening the AT042 on the side of the brass blade holder.
- Adjust the blade setting by increasing the tension on the ratchet. This will
remove the excess compound and leave a smooth finish for minimal sanding.
- Adjust the blade setting by
decreasing the tension on the ratchet.
For further information contact:
Website: www.tapepro.com
Tape-Pro Drywall Tools Pty Limited | 4/76 Dover Drive, Burleigh Heads QLD 4220 Australia
Phone: +61 7 5520 6022 Fax: +61 7 5520 5973 Email: [email protected]
