Item # 11987
T7924 1/10
STEP 1
Using the 1/4-20 bolts and lock washers provided, fasten the ProTrax/MaxTrax mounts to the Leg Set. The
snap buttons will be on the working side of the brake. Repeat for the other Leg Set. Be sure both ends of
the Snap Stand are going the same direction (with the snap buttons on the same side) See Figure 1 above.
STEP 2
Place the ProTrax/MaxTrax on the
Snap Stand Assembly with the rear
lip of the sub structure clearing the
rear clip. See Figure 2 above.
snap buttons are
toward working
side of saw table
rear lip
bypassing
rear clip
rear lip
STEP 3
The snap button will be
covered by the front sub
structure of the ProTrax/
MaxTrax. See Figure 3 above.
1. Removing the ProTrax/MaxTrax from the Snap Stand is essentially the opposite of attaching it to the stand.
2. Depress the snap button and pull the saw table forward far enough to hold each snap button down.
3. Be sure the lip on the rear sub structure is out of the Rear Clip. The ProTrax/MaxTrax can now be removed
from the stand.
4. Reverse Steps 1 and 2 on page 2 to disassemble the stand for transport.
STEP 4
Push the ProTrax/MaxTrax firmly
rearward into the rear clips. The
snap buttons will pop up and
secure the saw table on the Snap
Stand. See Figure 4 above.
S n a p S t a n d
S n a p S t a n d
Installing a ProTrax
™
or MaxTrax
™
Saw Table on Snap Stand
®
Removing the ProTrax or MaxTrax:
Figure 1
Figure 2
Figure 3
Figure 4
29797 Beck Road • Wixom, MI 48393-2834
3
use these clips
use these holes
© Boral Building Products Inc.
