3-2
A
LPHA
PID S
IGN
I
NSTALLATION
AND
M
AINTENANCE
M
ANUAL
(PN 1260600601 R
EV
.
B
)
Mechanical Installation
S
IGN
MOUNTING
GUIDELINES
AND
REQUIREMENTS
3
Sign mounting guidelines and requirements
Notice:
Do not use the sign’s ground-lug for grounding installation equipment such as welding equipment or the warranty
will be void. Only the sign sub-structure may be welded. Welding any other part of the sign, will void the warranty.
The method used to mount signs varies greatly from location to location. The installer must ensure the installation complies
with all national and local codes.
A qualified structural engineer must review the structure and attachment points to the super-structure. Sign installers must
comply with the following Adaptive requirements or the sign warranty will be void:
•
Any ID sign, fascia trim, or structure used above the sign must either have flashing or extend past the face of the
sign.
•
DO NOT
allow water to pool / gather underneath or on top of the sign.
•
DO NOT
allow water from an above ID sign, fascia trim, flashing, or any other structure to drip directly onto the
sign’s door seams.
•
DO NOT
seal the sign in any way that restricts hot air from escaping the inside of the sign.
•
Comply with all sign ventilation and clearance requirements. Refer to “Ventilation requirements” on page 3-3.
Notice:
Do not alter the factory applied finish of the sign. Any modifications to the sign housing will void the warranty.
Environmental requirements
•
Temperature is between -22 °F and 122° F (30°C -50°C).
•
Non-condensing humidity does not exceed 95%.
Summary of Contents for Adaptive Alpha Premier
Page 42: ...THIS PAGE INTENTIONALLY BLANK...
