INSTALLATION AND ASSEMBLY
3.2.1 Floor mounting
After placement and positioning, the floor mounting of the turnstiles should be carried out
according to the information given. Mounting brackets of the turnstile may vary by model and
category. Mark the leg parts of the turnstiles by drawing around the area where it touches the
floor.
(Figure 3.2)
Remove the mounting brackets screwed on the turnstile feet or body by using
an M6 hex key. (
Figure 3.3)
Figure 3.2
Figure 3.3
Place the mounting bracket on the floor 2mm inside by leaving equal space on the right and
the left, then mark the mounting points on the floor
(Figure 3.4)
. After marking all the brackets in
this way, connected them firmly to the floor by screwing in the holes
(Figure 3.5)
.
While screwing, pay attention to the position of the bracket that must have equal space on
the right and left.
Figure 3.4 Figure 3.5
| 14 |
