Quick Start Guide
CMS 3.0
SERIES
In-Ceiling
loudspeakers
CMS 603ICT LS
Page 1: ...Quick Start Guide CMS3 0 SERIES In Ceilingloudspeakers CMS 603ICT LS ...
Page 2: ...n Manual 2 SafetyNotices Some regional construction codes require the use of a secondary method of securing loudspeakers in ceiling to provide security of a back up support A secondary support line should be attached from the safety loop on the rear of the product to a source point on the ceiling For PI models the secondary support line should be attached from the back of the driver chassis to a s...
Page 3: ...in Section 4 above 4 Go to Section 7 following for instructions on wiring and set up instructions 5 Slide the speaker assembly through the hole Turn the screws denoted Screw Fix clockwise on the front of the speaker to extend the mounting wings Tighten the screws until a firm grip is achieved NOTE Screws have a PoziDriv head use of a PoziDriv driver is recommended If using a power driver Tannoy re...
Page 4: ...n be tapped at 60 W 30 W and 15 W with an additional 7 5 W tap for 70 V line systems 8 Dimensions Please refer to the full CMS Series Operation Manual for dimensional drawings CMS 603ICT LS Hole cut out 253 mm Diameter1 274 mm 10 79 Height2 273 8 mm 10 78 1 Maximum including bezel ring 2 Maximum to top of connector from lower ceiling surface Fig 1 Pin 1 is positive Pin 2 is negative For connection...
