Limited One Year Warranty
T&S warrants to the original purchaser (other than for purposes of resale)
that such product is free from defects in material and workmanship for a
period of one (1) year from the date of purchase. During this one-year
warranty period, if the product is found to be defective, T&S shall, at its
option, repair and/or replace it. To obtain warranty service, products must be
returned to.....
T&S Brass and Bronze Works, Inc.
Attn: Warranty Repair Department
2 Saddleback Cove
Travelers Rest, SC 29690
Shipping, freight, insurance, and other transportation charges of the product
to T&S and the return of repaired or replaced product to the purchaser are
the responsibility of the purchaser. Repair and/or replacement shall be
made within a reasonable time after receipt by T&S of the returned product.
This warranty does not cover items which have received secondary finishing
or have been altered or modified after purchase, or for defects caused by
physical abuse to or misuse of the product, or shipment of the products.
Any express warranty not provided herein, and any remedy for Breach of
Contract which might arise, is hereby excluded and disclaimed. Any implied
warranties of merchantability or fitness for a particular purpose are limited to
one year in duration. Under no circumstance shall T&S be liable for loss of use
or any special consequential cost, expenses or damages.
Some states do not allow limitations on how long an implied warranty lasts
or the exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you. Specific rights under this
warranty and other rights vary from state to state.
P/N:
DATE:
DRAWN:
CHECKED:
APPROVED:
098-014495-45 REV. 5
04-26-12
TEH
JRM 06-13-12
JHB 06-21-12
PRE-RINSE UNIT
B-0113-Y
(B-0133-BY, Pre-Rinse
Unit w/Wall Bracket)
Installation and
Maintenance
Instructions
Step 1:
Apply plumber’s putty to underside of body and
insert into mounting hole. With a wrench, tighten
upper locking nuts. Align spreader pins with blind
holes at base of shank and tighten spreader nut
to 12 ft-lbs. Assembly should not move or twist if
tried.
Step 4:
Grab riser assembly and lower the EasyInstall®
end-fitting into faucet body. Press down until the
end-fitting “pops” in.
Step 2:
Apply plumber’s tape to top of riser threads and
attach to spring assembly. Tighten with wrench.
Step 3:
Make sure that the EasyInstall® locking washer is
seated properly inside the faucet body.
Step 5:
Lock the EasyInstall® locking nut in place. Tighten
with wrench.
