Tandem t:slim X2, User Manual, Page: 57 / 198

Customer Technical Support:
(877) 801-6901 57
Key Pump Featur
es
2
Chapter 4 – Getting Started
at www.tandemdiabetes.com. This will
also allow communication between the
pump, the PC, and the t:connect Ap-
plication. Depending on your comput-
er, charging time will vary. The pump
will display a CONNECTION ERROR
ALERT message if it is not charging
properly.
To charge the pump using a
standard auxiliary-to-USB car
adapter (not included):
1. Plug the USB cable into the
auxiliary-to-USB car adapter.
2. Plug the car adapter into a
grounded auxiliary power outlet.
3. Plug the other end of the cable
into the micro USB port on the
pump.
WARNING
When using an auxilary-to-USB adapter, the
charger must be connected to an isolated,
battery powered 12 Volt system, such as in
a car. Connecting the DC car adapter to 12
Volt DC that is generated by a power supply
connected to an alternating current (AC) source
is prohibited.
When you charge the t:slim X2
Pump, you will notice the following:
•
The screen illuminates
•
An audible alert
•
The LED (edge around the Screen
On/Quick Bolus Button) blinks
green
•
A vibrating alert
•
A charge symbol (lightning bolt) on
the battery level indicator appears
PRECAUTION
CONFIRM that the screen display turns on, you
can hear audible beeps, feel the pump vibrate,
and see the green LED light blinking around
the edge of the Screen On Button when you
connect a power source to the USB port. These
features are used to notify you about alerts,
alarms, and other conditions that require your
attention. If these features are not working,
discontinue use of the pump and contact
Tandem Diabetes Care Customer Technical
Support at (877) 801-6901.
Charging Tips
Tandem Diabetes Care, Inc. recom-
mends periodically checking the bat-
tery level indicator, charging the pump
for a short period of time every day
(10 to 15 minutes), and also avoiding
frequent full discharges.
NOTE: Fully Discharged Battery
If the battery is fully discharged, the screen may
not power on immediately when connected to
a charging source. The LED around the Screen
On/Quick Bolus Button will blink green until
there is enough charge to power on the touch
screen.