background image

WHAT’S IN THE BOX?

1. CONFIGURE

2. INSTALL AND CONNECT

 

 

 

www.tandeltasystems.com
[email protected]
Copyright © Tan Delta Systems Ltd.

OQSx-G2

Cable J

Sensor & Cable J available separately as SENSE-1 Kit

Product

USB

LAN 

Port

USB 

Port

Micro 

SIM

LED 2 LED 3 LED 4

LED 1

S1

S2

S3

Gateway

Power

66

19

6x Ø6.5

165

Cable HP

Cable GH

HCP-1

Cable SH

OQSx-G2

SENSE-3 Unit

Best practice is to configure all cables
before powering on the system.

1. Install all sensors to their intended assets.
2. Mount the SENSE-3 unit to a wall or rigid 

surface using any 4 of the 6x Ø6.5 clearance 
holes. Ensure IP67 cover is attached.

3. Check Cable GH has been preconnected when 

shipped. If not, connect it as shown.

4. Route all Cable SHs from sensors to slots 

S1/S2/S3.

5. Populate any unused slots with Continuity 

Plugs (HCP-1).

6. If using a 4G SIM, attach the antennas 

to the Gateway.

7. Connect Cable HP and apply power 

(9-30VDC).

8. Check data is coming through on 

TD Online for each sensor.

9. See Master User Guide for

 troubleshooting help.

 

 

 

 

GATEWAY KIT 

I

 

SENSE-3 

QUICK START GUIDE

1. Allow Configuration Cable to install and update drivers.
2. Install CADS from USB or by scanning the QR code or 

go to: 

www.tandeltasystems.com/support/

3. Select the Modbus RTU over RS485 comms protocol.
4. Set unique Node ID from 1-16 for each sensor.
5. Ensure 9.6000 Kbps Bit Rate is selected.
6. Select desired oil for each sensor.
7. Configure Gateway network for 4G SIM, WiFi, 

or Ethernet using the Gateway Configuration Tool on 
the USB. Save “.conf” configuration file.

8. Connect Cable HP to Gateway Hub. LED 3 will have 

a steady green light.

9. Insert USB into Gateway. LED 2 will turn red for 

a few seconds, then all LEDs will go off. Remove USB 
at this point. 

10. After 1 minute, the Gateway will reboot. LED 3 will 

have a steady green light. LED 4 will have a steady
amber light once the Gateway has connected 
successfully to TD Online.

SCAN ME

SENSE-3 Unit (Gateway pre-assembled 

with Gateway Hub and Mounting Kit)

Quick Start

Guide

USB Stick containing

• Gateway Configurator 

• Software 

• CADS

• Master User Guide

Gateway Hub to Gateway Cable 0.2m

(Cable GH)

Gateway 4G Antenna 

Cable

2x Gateway Hub Continuity Plug

(HCP-1)

Gateway Hub Power Cable 10m

(Cable HP)

Reviews: