Installing the Equipment
Reference Guide: Voyager E5784 and E5788 HD DSNG Encoder
Page 2-19
ST.RE.E10137.3
2.6.2 Powering
Up
To power up the Encoder:
1. Turn on the local power supply. The Encoder executes a series of
power-up initialisation and self-test routines.
2. Confirm that the green Power LED is lit and that the red Alarm LED is
unlit.
3. Ensure that the Stand-by switch is set to On (see Chapter 1,
Introduction, Figure 1.8).
After the boot period the Encoder Input Monitor screen is displayed.
NOTES…
1.
The fans on the Encoder can be temperature controlled so may not be on if the ambient
temperature is low. Refer to Annex B, Technical Specification for more information.
2.
During initialisation invalid PIDs may appear momentarily in the transport stream.
2.6.3 Powering
Down
To power down the Encoder remove the power supply connection at the
rear of the unit.
2.7
Setting the Encoder IP Address
2.7.1
Methods of Changing the Encoder IP Address
If, for any reason, the IP address has to be changed, this can be achieved
via the front panel menus (see Section 4.7.4 Remote Control Menu). The
user may also set the network mask.
NOTE…
The new IP address is only accepted after the Encoder is repowered.
2.7.2
From the Front Panel Menus
To access the IP Address option from the front panel menus, press the IP
Address softkey in the
Remote Control Menu
. Edit the IP address via the
keypad and then press the Enter softkey.
IP Address
←
Left
Encoder IP Address :
+
→
Right
`172.16.248.91’ —
O
Enter
●
O
Update using softkeys
Quit
●
Figure 2.6: Changing the Encoder IP Address