Installing the Equipment
Page 2-10
Reference Guide: Voyager E5784 and E5788 HD DSNG Encoder
ST.RE.E10137.3
2.5.2
Connecting Up the Basic Encoder
Once the unit has been installed in its intended operating position, it is
ready to be connected up to the rest of the system equipment
(see Figure 2.5), providing it too has been installed (see Section 2.5,
Figure 2.5 for pin-out details of the connectors).
Figure 2.5: Equipment Connections for the Basic Unit
Do not move or install equipment whilst it is still attached to the mains
supply. Ensure ESD precautions are observed whilst interconnecting
equipment.
NOTE…
See Chapter 3 for information relating to Options and Upgrades.
Encoder
Video Input
SDI IN
HD SDI IN
H SYNC
COMP VIDEO
Audio input
AES/EBU Reference
ETHERNET #1
ETHERNET #2
REMOTE CONTROL
Audio Input
Control
RS-232 data input
RS-422 data input
Alarm and Monitoring
DVB/ATSC Transport stream output
Output
Alarm
ASI OUT 1
ASI OUT 2
ASI OUT 3
ALARM
10BaseT
10BaseT
RS-232/RS-485
AUDIO IN
DVB/ATSC Transport stream output
DVB/ATSC Transport stream output
SD Serial Digital Interface
Analogue composite video
Studio Black and Burst
Data
RS-232 DATA
RS-422 DATA
HD Serial Digital Interface
Main Output
Modulator (IF)
OUT MAIN
OUT MONITOR
Monitor Output
L-Band In
Modulator (L-band)
L-BAND IN
L-BAND OUT MAIN
L-BAND OUT MONITOR
L-Band Monitor Output
L-Band Main Output