OPERATORS MANUAL
TT1200 MPEG2-DVB PROFESSIONAL DECODER
PAGE 47
TANDBERG TELEVISION ASA, Philip Pedersensvei 20, PO Box 322, N-1324 Lysaker, Norway
Tel: +47 67 11 62 00, Fax: +47 67 11 62 01
Description of the Card status:
2.
The communication with the smart card is working.
1RWSUHVHQW
There is no smart card in the smart card slot.
1RWUHVSRQGLQJ
The smart card is not inserted properly or not recognized.
Description of the Video, Audio and Ttxt status:
Clear
The component is clear and no smartcard is required
Descram
The component is scrambled and the smartcard has access
No access
The component is scrambled and the smartcard has no access
Clear & CA
The component is clear but is signalled as scrambed. No smartcard is required
Incom SC/CA
The component is signalled as scrambled and either the smartcard fails to accept the
CA descriptors, or the CA type in the stream is not compatible with the smartcard
Searching
The decoder has not yet decided the status of the component
Fixed Key
Fixed Key CA is enabled (
Setup
⇒
System Options
⇒
CA Mode = Fixed
Key
)
5.5.4.2 Smart Card Menu
The smart card has its own menu where specific information about the smart card can be read. In order
to enter the smart card menu, choose the CA-Module menu. The menu will only appear if a valid smart
card has been inserted prior to the selection and if the software supports the specific smart card type.
The information found in the menu may be subscription period, smart card address etc., but are totally
dependent on the smart card implementation and may vary from card to card. For information about the
smart card menu see additional smart card information or contact the smart card vendor.
5.5.4.2.1 Conax CA-system
Note that this section only applies to software versions x.xxxVC.
After inserting the Conax smart card into the decoder, the Conax consultation menu is enabled through
the
Status
⇒
CA-Module
menu.
The information found in the menu may be subscription period, smart card address etc. , but are totally
dependent on the smart card implementation and may vary from card to card. For information about the
smart card menu see additional smart card information or contact the smart card vendor.
5.5.4.2.2 Viaccess CA-system
Note that this section only applies to software versions x.xxxVC.
After inserting the Viaccess smart card into the decoder, the Viaccess consultation menu is enabled
through CA-Module in the main menu as shown in Figure 29.
