OPERATORS MANUAL
TT1200 MPEG2-DVB PROFESSIONAL DECODER
PAGE 39
TANDBERG TELEVISION ASA, Philip Pedersensvei 20, PO Box 322, N-1324 Lysaker, Norway
Tel: +47 67 11 62 00, Fax: +47 67 11 62 01
SET:ADVANCED
System Options>
Output Setup>
Alarm Setup>
RS232 Setup>
Remote control>
reset
ALL
default Setup?
ADV:ALARM SETUP
Demod>*
ASI IN>*
Irdeto>
TV Ch>
Audio2>
AL.SET:DEMOD
No Sync
A
Margin < 0dB
A
BER > 10e-4
A
No input signal A
Input pwr HIGH
-
Input pwr LOW
-
AL.SET:AUDIO2
...
AL.SET:TV CH
Out of sync
A
SC not present
A
SC bad response A
SC no response
A
CAM: EEPROM inv
CAM: No CAT rec
...
AL.SET:IRDETO
CAM restarted
W
No free CAM slo
-
No CAM-IF found
-
No CAM present:
A
CAM initialisin
W
Device not Read
W
...
ASI IN
No Sync
Buffer overflow
Figure 22 Alarm setup menu
The
Status
⇒
Alarm
menu is then used to investigate the status of the decoder and to check if any of
the preset conditions have occurred. Please refer to section 5.5.1 for more details about the
Status
⇒
Alarm menu
.
5.4.5.4 RS232 Setup menu
This menu is used to set up the data output service at the RS232 port. Note that if
Remote control
is
configured to
TTV (RS232)
, the
RS232 Setup
menu will not be configurable and the data output can
not be used. In this case the message
Remote controlled
will be displayed when attempting to enter
the
RS232 setup
menu.
