Installing the Equipment
Page 2-12
Reference Guide: evolution 5000 E5780 and E5782 Encoder
ST.RE.E10135.4
H SYNC
Studio Black and Burst should be fed to the 75
Ω
BNC connector
(H SYNC). This will then genlock the Encoder to the Studio system.
This method may be required with some audio formats, or for locking
Encoders to an evolution
5000
Multiplexer. For details on the
genlocking system see
Annex F, Audio Modes
.
Table 2.5: H SYNC Connector
Pin Signal
Centre Video
Input
Screen Ground
Impedance 75
Ω
COMP VIDEO
A 75
Ω
BNC connector provides a high quality analogue video input
to the unit. See
Chapter 4, Operating the Equipment Locally, Video
Input Option
on
page 4-28
for the types of video and selection
method.
NOTE…
The input is differential to prevent 50 Hz/60 Hz hum.
Table 2.6: COMP VIDEO Connector
Pin Signal
Centre Video
Input
Screen
Video Input Return
Impedance 75
Ω
2.6.6 Audio
Inputs
Connect the audio cable to the
AUDIO
IN
connector. The 15-way,
D-type male connector is used in different ways according to the
audio input and the encoding configuration selected.
The connector provides two stereo pairs. They may be independently configured as either
analogue or digital. The left channel is used to input digital audio.
The Encoder is supplied with a
break-out cable
which plugs into this connector, and provides
a more convenient means of connecting the audio signals via five connectors. There are four
XLR female connectors, with the fifth cable being a BNC which provides an AES/EBU 75
Ω
digital reference output.
