TANDBERG E5714 DSNG Voyager, Reference Manual, Page: 149 / 314

Operating the Equipment Locally — Audio Menu: Dolby (AC-3) Pass-thru, Dolby E Pass-thru and DTS Pass-thru Menu
Reference Guide: E57xx DSNG and DENG Voyager Encoder Page 4-71
ST.RE.E10076.3
PCR On Audio PID Option
This option controls whether PCR should be signalled on the audio PID.
This may be necessary if an audio only service is being generated. The
default setting is Off.
OP Digital Loss
This option controls behaviour digital audio is not locked. See Table 4.44
for options.
Hardware Release Option
This option indicates the hardware version of this audio encoder channel. It
is for status only and cannot be changed.
Software Release Option
This option indicates the software version of this audio encoder channel. It
is for status only and cannot be changed.
4.9.5 Audio (Linear PCM) Menu
Source Option
This option defines the audio source.
Table 4.68: Source Options
Selected Option Description
Off No audio packets are sent in the transport stream and audio is removed from the SI.
Mute Audio silence.
Test Tone An internally generated test tone is used as the audio source. The bit-rate automatically changes
to 96 kbit/s.
Analogue Analogue audio input on AUDIO IN connector.
Digital Digital audio input on AUDIO IN connector.
SDI Embedded 1 Digital audio de-embedded from digital video input using DID 0x2FF.
SDI Embedded 2 Digital audio de-embedded from digital video input using DID 0x2FF.
SDI Embedded 3 Digital audio de-embedded from digital video input using DID 0x1FD.
SDI Embedded 4 Digital audio de-embedded from digital video input using DID 0x1FD.
These are default DIDs