11
Video Mode
Video Mode options allows the user to select the
correct Video Format. The video mode selected must
match the video format being received for the IRD to
display the video correctly. When video selection is
made, the IRD will reboot then output the video in the
correct video format.
Audio Mode
Audio Mode option allows the user to direct one of the
channels to both IRD audio connectors.
Closed Caption
Closed Caption screen will only appear when the Video
Mode has been selected to NTSC. Closed caption can
be selected on or off.
Reset Factory Default
Reset Factory Default feature allows the user to
change all the IRD settings to the default settings. The
default settings are shown in the Menu Tree diagram.
Boot Version
Boot Version displays the version number of the IRD’s
boot software. The version number will change if the
boot software is changed through over-the-air
download.
NIM Version
NIM Version displays the version number of the IRD’s
Network Interface Module (QPSK Receiver) software.
The version number will change when the NIM software
is changed through over-the-air download.
Software Version
Software Version displays the version number of the
IRD’s top level software. The version number will
change if the software is changed through over-the-air
download.
Verifier Version
Verifier Version displays the version number of the
IRD’s conditional access (Verifier) software. The
version number will change if the Verifier software is
changed through over-the-air down load.
Eb/No (Energy over Noise)
Eb/No display will only appear when the IRD has
successfully received a signal. It is desirable to have a
high signal to noise ratio.
BER (Bit Error Rate)
BER reading provides information on bit error rate.
Packet Error Rate
Packet Error Rate provides information on packet error
rate.
ID Number
The ID number displayed is the IRD ID number. This
number can be used to identify the IRD when getting
the IRD authorized.
Pre-Set Channel
The Pre-Set Channel screen is used to tune the
CSR820 to a pre-set channel from the service
provider’s transport stream.
The CSR820 stores 12 pre-set channels. Channel 11 is
reserved for Power Up. Channel 12 is the Emergency
Home channel.
The Pre-Set Channels screen allows the operator to
tune to any of the Pre-Set Channels, but does not allow
any change to any of the channel settings.
To clear all items in the Pre-Set Channels memory,
reset the factory defaults.
If the Power-Up channel is not available the CSR820
will display “Memory Not Set 11” and the IRD will tune
to the last channel prior to power down.
Customer Service Information
If you have problems installing or operating the unit
after you have carefully followed the instructions in this
manual, contact Tandberg Television Customer Service
for assistance or service.
Confirmed defective units should be returned to the
Tandberg Television repair center. Return authorization
may be required, and return instructions can be
obtained by contacting Tandberg Television.
Customer Service Telephone Numbers
Be sure to write down the Serial Number of your
CSR820 (located on the rear panel) before calling
Tandberg Television Customer Service.
You may contact customer service at one of the
following numbers:
1-888-637-0023 (United States only)
or
(949) 725-2699
Tandberg Television
Customer Service Department
25901 Commercentre Drive
Lake Forest, CA 92630 USA
