5
OF
12
I
NSTALLING
A
DDITIONAL
T
APE
D
RIVES
To install an additional tape drive, follow these steps:
1.
1.
1.
1.
Preparing for replacement
—
a.
a.
a.
a.
Power off the host.
b.
b.
b.
b.
Power off the library (press the
0
on the back of the unit).
c.
c.
c.
c.
Disconnect the power cord, the SCSI or Fibre Channel cable(s), and the terminator (if one is installed).
d.
d.
d.
d.
Remove the tape drive cover plate. Set the plate and the screws aside.
Note:
This figure shows the SCSI library. Remove the Fibre Channel tape drive cover plate the same way.
2.
2.
2.
2.
Removing the internal cooling plates and disconnecting cables
—
a.
a.
a.
a.
Remove the two screws (
A
) holding the tape drive cooling plate (
B
). Remove the plate, and discard it and
the screws.
b.
b.
b.
b.
Disconnect all of the power cables (
P
).
3.
3.
3.
3.
Installing the tape drive
—
Figure 6
Tape drive cover plate (HH SCSI library)
Figure 7
Tape drive cooling plate
Power OFF
Disconnect
power cord
Tape drive
cover plate
(press the
0
)
Back of library
Screws (2 each side)
Cooling plate
(
B
)
Looking inside back of library
Screws (
A
)
Summary of Contents for Magnum 224
Page 1: ......
