TX7211 Addressable Sounder Circuit Module
Installation & Operation Manual
4050100453-Rev1.1-1217
TANDA UK
Specifications are subject to change w ithout prior notice
6
3 Addressable Sounder Circuit Module Unit Configuration
3.1 Preparation
The TX7930 handheld programmer is used to configure
Addressable Sounder Circuit Module Unit soft
address and parameter. This tools are not included, must be purchased separately. The programmer
is packed with twin 1.5V AA battery and cable, ready for usage once received.
It is mandatory for the commissioning personnel to have programmer tool in order to adjust the
Unit
conferring to the site situation and environmental requirements.
Program a unique address number for each device according to the project layout before placing
from the Terminal Base.
Warning: Disconnect the loop connection whilst connecting to the handheld programmer.
3.2 Write: Addressing
1.
Connect the programming cable to Z1 and Z2 terminals (Figure 3). Press “Power” to switch on
the unit.
2.
Switch-on the programmer, then press button “Write” or number “2” to enter Write Address
mode (Figure 4).
3.
Input the desire device address value from 1 to 254, and then press “Write” to save the new
address (Figure 5).
Note:
If display “Success”, means the entered address is confirmed. If display “Fail”, means
failure to program the address (Figure 6).
4.
Press “Exit” key to go back Main Menu. Press “Power” key
to switch-off the programmer.
Terminal Description
Z1 Signal In Non-polarity
Z2 Signal In Non-polarity
D1 External Power Supply In Non-
polarity
D2 External Power Supply In Non-
polarity
L+ Remote Indicator (+)
L- Remote Indicator (-)
Figure 2: Wiring
