Tanco S200V Quick Reference Manual Download Page 1

Page: 1 / 4

TRACTOR CONNECTION

1. Hydraulics

Red pipe

> Supply (35-40lpm)

Blue pipe

> Return (

Free flow return!!)

2. Electrics

A. Connect 12V supply to 3pin plug

B. Connect wrapper harness to controller

ENTERING THE WORKING POSITION

1. Remove the wrap arm transport lock.

2. Position the safety arms into the working

position by removing the retaining pin.

3. Adjust the load arm stop pin to allow

clearance between the top of the bale at the

rotating arm.

4. Unfold the wrap arms and install the 2/3

rolls of film.

The quick reference guide is not a substitute for the Operators Manual!

Please refer to Operators Manual for more detailed information

S200V / S300V QUICK REFERENCE GUIDE

Summary of Contents for S200V

Page 1: ...ansport lock 2 Position the safety arms into the working position by removing the retaining pin 3 Adjust the load arm stop pin to allow clearance between the top of the bale at the rotating arm 4 Unfo...

Page 2: ...l then begin 4 Press the Rollers out button c to offload the bale a b c Using the End Tip Note End Tip must be set to ON in the Operator Settings 1 Press the Rollers out button a The End Tip will firs...

Page 3: ...e red button on the rear of the remote must be pressed while pressing any other button except STOP Current No of wraps Target No of wraps Wrapping speed RPM Bale total Grand total No of bales Mode Man...

Page 4: ...arm transport lock 5 Lock the outer safety arm into the transport position 5 4 OPTIONAL HANDHELD REMOTE The operator can activate the main wrapper functions through the handheld remote This means that...