Tanco 1400 V Quick Reference Manual Download Page 1

Page: 1 / 4

TRACTOR CONNECTION

1. Hydraulics

Red pipe

> Supply (35-40lpm)

Blue pipe

> Return (

Free flow return!!)

2. Electrics

A. Connect 12V supply to 3pin plug

B. Connect wrapper harness to controller

C. Connect hand remote to controller

ENTERING THE WORKING POSITION

1. Switch on controller using the red switch
2. Enter the

Auto Park Sequence

A. Press the Down arrow to get to the Auto Park Sequence

B. Press Enter

C. Press and hold the

Unfold drawbar

button until

End

displayed.

3. Install the 2 rolls of film

4. Set the Auto Load paddle into the

working position (if using Auto Load).

The 1400V wrapper will now be in the working position

The quick reference guide is not a substitute for the Operators Manual!

Please refer to Operators Manual for more detailed information

1400 V QUICK REFERENCE GUIDE

Summary of Contents for 1400 V

Page 1: ...h 2 Enter the Auto Park Sequence A Press the Down arrow to get to the Auto Park Sequence B Press Enter C Press and hold the Unfold drawbar button until End is displayed 3 Install the 2 rolls of film 4...

Page 2: ...load a b 1 Auto mode A Auto offload 1 Drive into the bale 2 Press the Load up button on the remote a or on the controller b to load the bale 3 Press Auto start on the remote c or controller d to begin...

Page 3: ...old the Fold Drawbar button until End is displayed HAND REMOTE OPERATION Manual Mode M Table down Auto Mode A Start autounloading Manual Mode M Loadarm out Auto Mode A Start autowrap Manual Mode M Tab...

Page 4: ...perating Mode M or A Power On Off Emergency Stop L5 Load Bale L4 Slow reverse arm L3 Slow wrap forward L2 Close C S L1 Fold drawbar position 4 way Menu switch Set no of wraps Change Reset bale sub tot...