tams elektronik MT-1, Manual, Page: 7 / 36

tams elektronik
!
!
MT-1 | MT-2 | MT-3 English
Caution:
Little children can swallow small components with sharp edges, with
fatal results! Do not allow components to reach small children.
In schools, training centres, clubs and workshops, assembly must be
supervised by qualified personnel.
In industrial institutions, health and safety regulations applying to
electronic work must be adhered to.
3. Safe and correct soldering
Caution:
Incorrect soldering can coffe dangers through fires and heat. Avoid
these dangers by reading and following the directions given in the
chapter
Safety instructions .

Use a soldering iron with temperature control, which you set to
approx. 300 °C.

Only use electronic solder with a flux.

Never use soldering water or soldering grease when soldering
electronic circuits. These contain an acid that destroys components
and conductor paths.

Insert the connecting wires of the components as far as possible
through the holes of the board without using force. The body of the
component should be close above the board.

Make sure that the polarity of the components is correct before
soldering them.

Solder quickly: soldering for too long can coffe pads or tracks to
become detached or even destroy components.

Hold the soldering tip on the soldering point in such a way that it
touches the component wire and the pad at the same time. Add (not
Seite 7