6
of film then tighten the screw on the adapter to secure the roll film. Load the rods on the laminator and
adjust accordingly to make sure the film and the kraft paper are aligned.
THREADING THE FILM
Read the threading card supplied with each roll of film carefully. Do not mistake the stabilizer bar for
the idler roller.
1. To thread the film through the “hot rollers” & “pull rollers”, please push the handle forward to
release pressure on all the rollers. Insert the handle pin into the farthest notch to lock the handle in
place. Make sure the film is correctly threaded based on the threading guide.
2. Peel the leading edge of top film to expose the release liner. Fix the edge of the liner on the
receiving roller by using tape. Please see drawing below.
3. Pull the film out and lean the glossy side evenly to the top feed roller.
4. Take the leading edge of the threaded kraft paper and apply evenly onto about an inch from the
leading edge of the adhesive side of the laminating film.
5. Make sure the roller tension is the same between the top and bottom rolls. It is important that there
is sufficient tension for the receiving roller to remain in tandem with the speed of liner being
released from the cold film. (Please refer to “ADJUSTING THE FILM TENSION” on page 2.)
