5
2. Push the film through the rollers with a threading card and make sure the film is correctly threaded
based on the threading guide.
ADJUSTING THE TEMPERATURE & SPEED
1. Turn on the power switch and make sure to turn off the “BOTTOM ROLLER HEATER” switch on
the right side of machine.
2. Press the “U” key and the digital screen display will show the previous temperature setting of upper
roller. Adjust the upper roller temperature by pressing the “TEMP/SET” “
︿
” or “
﹀
” arrow keys
and the digital screen display will beep showing the set temperature for 3 seconds before showing
the actual machine temperature.
3. Once the temperature is set, press the “HOT” key to start the heating process and the heater light
will turn on. Once the set temperature is achieved and roller temperature is stabilized, the machine
will start beeping and the ready light will turn on. Once the ready light stays on, you can set the
recommended speed.
4. Press the “MOTOR” “
︿
” or “
﹀
” arrow keys to set the motor speed. The following table gives
some common temperature/speed setting for typical uses.
Nylon Film Thickness
Temperature
Speed
0.5 Mil (12 Micron)
100°C(212°F)
3 ~ 4
5. Turn on the rear fans to prevent the film from bunching in the back of the machine.
LAMINATING PROCEDURES
1. Release the handle from the locked position and insert the handle pin into the “MIN.” notch to
engage the rollers. Make sure the motor switch is in “RUN” position. The user can now start
laminating as the machine starts feeding in film.
2. To put the lamination temporarily on hold without turning off the machine, the user can turn the
motor control switch to “STOP” position. This will cause the motor to stop running and the film
will stop feeding.
3. To resume the lamination job, turn the switch to the “RUN” position again.
(3) COLD LAMINATION
LOADING THE FILM
Unpack the upper and lower supply rods. Install cold laminating film with liner on the upper rod by
following an adapter---film---adapter sequence onto the rod and fit the adapters onto the paper core.
Using the same installation sequence, install a kraft paper roll of the same width as the top film onto
the lower supply rod. Leave equal lengths of the rod out of each end. Use the guide to position the roll
