1
OPERATING INSTRUCTIONS
TCC1200
1 IMPORTANT SAFEGUARDS
When using electrical machines, basic precautions should always be followed to reduce the risk of
electric shock and injury to people, including the following:
1.
Read all instructions.
2.
Please note that this machine runs on 220V/60Hz with a rated current requirement of 12A~14A
and comes with a single phase
NEMA L6-20
AC plug. Make sure the location where the machine
will be installed has the corresponding power source and receptacle appropriate for the machine’s
electrical specifications.
3.
Always unplug the machine when not in use or before cleaning.
4.
Do not use outdoors.
5.
Extreme caution should be taken when the machine is used by or near children or disabled
persons.
6.
To protect against risk of electrical hazards, do not immerse cord, plugs, or the whole machine in
water or other liquids.
7.
Do not operate the machine with a damaged cord or plug, or after the machine malfunctions, has
been dropped or is damaged in any manner. Return the machine to the nearest authorized service
facility for examination, repair, or adjustment.
Please keep the original packaging to ensure that
the machine is secure and protected when returning for repair. This is particularly important
when returning the machine for repair within its warranty period.
8.
Do not use accessory attachments not recommended or sold by the machine’s manufacturer.
9.
Do not let the cord touch hot surfaces or hang over the edge of the work table.
10.
Do not use the machine for other than its intended use. This machine is intended for Office or
Household use only.
11.
The socket outlet shall be near the machine and shall be easily accessible.
12.
Warning-hazardous moving parts-keep fingers and other body parts away.
2 LOCATION
1. Please remove the laminator carefully from its packaging and place it on a flat work surface. Place
the machine in an area where it will normally be used, ensuring adequate room for the finished
laminate to flow or slide out at the back.
2. Please install the shield and feed tray at the correct positions until the two LED lights on the left
side panel turn off, otherwise the machine will not feed the film.
