TAGT2 Transmitter
Features & Functions
1
- Transmitter Antenna
2
- Steering Wheel
3
- Throttle/Brake Control
4
- Steering Reverse Switch
5
- Power LED
6
- Steering Trim
7
- Power Switch
8
- Throttle Reverse
9
- Power Check LED
10
- Bind Button
11
- D/R Trim
12
- Throttle Trim
13
- Battery Compartment
4
5
6
7
8
9
10
11
12
1
2
3
13
Binding Process
A binding feature is included with the TAGT2 Handset to ensure the transmitter and receiver bind properly and prevent interference from other
controllers. To bind your transmitter and receiver, please follow the steps below.
1
- Install batteries (6 x AA, not Supplied) into the transmitter, but do not switch ON.
2
- Insert the “match line” unit (supplied) into the Ch3/Bind port of the receiver.
3
- Connect the receiver battery supply to the VCC port on the receiver and switch ON.
Now the 2 LED lights are flashing, awaiting signal.
4
- Press and hold down the BIND button on the transmitter, then turn on the transmitter. (apx 5 secs)
5
- Watch the flashing LED’s on the receiver until they stop. The Transmitter & Receiver are now matched.
6
- Release the BIND Button on the transmitter and remove the “match line” from the receiver.
7
- Install servo cables.
8
- Switch ON car first, then the TRANSMITTER.
9
- Check that the binding process was successful by moving the controls.
10
- If it has NOT worked, please repeat the stages above
BIND
Controls
X5 Overview
Summary of Contents for X5 1:5 Brushless Buggy
Page 16: ......
