TallyGenicom 9050N -, User Manual

Page: 77 / 172

User Manual 5-19
PRINTING FROM A MACINTOSH COMPUTER
Networking
PRINTING FROM A MACINTOSH COMPUTER
PRINTING FROM A MACINTOSH COMPUTER
This section explains the installation procedure for printing from a Macintosh computer.
SYSTEM CONFIGURATION
As the printer supports EtherTalk and LPD protocol, you can print from Macintosh. NOTE >
Printing using the LPD protocol is available only with the Mac OS X.
TARGET COMPUTERS
The printer supports a Macintosh or Power Macintosh with the following OS:
• Mac OS 10.2 and up
SET UP PROCEDURE
The setting procedure is as follows:
1.
Use the printer Operator Panel or EWS to set the following port to [Enable].
NOTE: The EWS allows more detailed settings.
2. Setting up the Macintosh
Add the printer ppd onto the Macintosh. Connect the printer to the network and select
Add Printer via the printer setup utility or Printers and Faxes and the Plus button. Select
Other using the Print Menu and browse to and select the 9050 ppd. Then add any options
that have been installed on the printer.
SNMP SUPPORT
The printer can be managed via a standard SNMP management station. The printer supports
SNMP-v1, SNMP-v2c, MIB-II, Host Resources MIB, and Printer MIB.
PRECAUTIONS AND LIMITATIONS
ON USING TCP/IP
This section explains the precautions and limitations of using this printer with TCP/IP.
Setting Up the Printer
• Be very careful in setting up IP addresses which are controlled as an entire system.
Consult your network administrator before performing any setup on IP addresses.
• Depending on the network environments, some require subnet mask and gateway to be set
up. Consult your network administrator and set up the necessary items.