TallyGenicom 6605, User Manual

Page: 82 / 212

82
Chapter 4
Config Menu
MTPL Bar
Setting this parameter will print out barcodes for MTPL. Otherwise, the
sequences will be printed as text only. The selections are ON and OFF, with
the default being OFF. This parameter only affects the MTPL emulation.
MTPL Secured
In secured mode (ON), normal text characters can be printed to the right or
left of barcodes. In unsecured mode (OFF), it is not possible to print more
than one line with normal characters in the bar code line. The default is OFF.
This parameter only affects the MTPL emulation.
Ignore Term
Determines whether or not a line feed following the CR terminator, an SFOFF,
or an IGOFF command will cause a line feed to occur. There are two options:
Enable (usually the default) and Disable (the default for Genicom ANSI).
•
Disable. A LF following the CR terminator, SFOFF, or IGOFF command
will execute.
Example: ~SFOFF<cr><lf>
~IGOFF<cr><lf>
•
Enable. A LF following the CR terminator in the above example will not
execute.
PGL Terminator
Determines whether or not a CR-LF terminator for PGL commands will cause
a line feed to occur.
•
CR. Allows line feeds which follow the carriage return to be executed.
Example: ~EXECUTE;TEST<cr><lf>
<cr><lf>
~NORMAL<cr><lf>
The above example would execute three line feeds following the job TEST.
•
CR-LF (default). Will not execute line feeds following a carriage return. In
the above example, the LFs would not execute.
BlkMaxH, BlkMaxV, BlkMinH, BlkMinV
These four parameters provide the ability to create block characters using
FreeType fonts. However, the user may find that very small FreeType
characters are not legible, and very large FreeType characters may print too
slowly. These four allow the user to select the minimum and maximum
horizontal and vertical size of block characters that will be generated using
the FreeType characters.
Postnet Density
Determines whether POSTNET bar codes are printed in Low Density (72 DPI)
or High Density (144 DPI). Low Density is the default setting. POSTNET bar
codes printed in High Density wil print at half the speed of Low Density.