TallyGenicom 6605, User Manual

Page: 79 / 212

Graphics Submenu
79
Code V Cmd Char
This parameter allows you to change the CVCC. The Default for this
parameter is the ASCII caret ( ^ , Decimal 94, HEX 5E) character.
Smooth Size
This parameter controls the size at which block characters are smoothed.
The default is 3, which means that size 3 block characters will be smoothed,
but size 2 block characters will not. This parameter is used by Code V and
PGL.
PY Then
This parameter defines printer response to characters following the ^PY
Command on the same line.
•
None (default). All data, plus the line terminator are ignored.
•
All. All data is executed.
•
Term. All but the terminator is ignored.
•
Free Format. Depends on the state for Free Format Mode.
PN Then
This command defines printer response to characters following the ^PN
Command on the same line.
•
None (default). All data, plus the line terminator are ignored.
•
All. All data is executed.
•
Free Format. Depends on the state for Free Format Mode.
NOTE: For PY Then and PN Then, even though Code V documentation
states that all other data on the line is ignored, some Code V
installations do not follow this rule.
Dark Bar
This parameter allows you to set the base dot density at which bar codes will
print. Default is Low.
All barcodes will print at the selected density unless the user program
requests a higher density. When the user program requests a higher density,
the printer will switch to the next higher density than the base density. The
following table shows the density selections and how they change when the
printer receives a program request for a higher density:
DarkBar Selection Normal Mode Dark Mode
Low (Default) 60 x 72 60 (120) x 144
Medium 60 (120) x 144 120 x 144
High 120 x 144 120 x 144