TallyGenicom 6605, User Manual

Page: 64 / 212

64
Chapter 4
Operator Menu
Length (Lines)
To define the length of your form in lines, select a form length from 1 to 255.
The default option is 66.
Length (Inches)
To define the length of your form in inches, select a form length from 0.1 to
25.5 inches. The default is 11.0 inches.
LPI
This allows you to set the lines per inch. Possible selections are 1.5, 2, 3, 4, 5,
6, 8, 9, 10, and 12. The default is 6 LPI.
Top Margin
This parameter dictates where the first print line is located on the page. The
Top Margin location is measured in lines from the current Top-of-Form
location. The range is 0 to 255, with the default at 0.
Bottom Margin
This parameter allows you to set the bottom margin. The Bottom Margin is
measured in lines from the current Top-of-Form location. The range is 0 to
255, with the default at 66.
NOTE: The Bottom Margin and Top Margin selections are translated into a
physical location on the page. Subsequent changes in LPI affect this
location. If the new location does not exactly correspond with a line
position, no asterisk is shown as a "current setting" indicator.
For example:
The initial Bottom Margin selection is line 60 and the current LPI is 6.
The Bottom Margin location would be 10 inches from the Top-of-Form
location. If the LPI is changed to 10 LPI, the selection for Bottom Margin
would change to line 100.
Left Margin
You can place the left margin at any column number across the page, using
selections 1 to 272. The range of selections for this parameter depends on the
CPI setting. Column 1 is the Default. The left margin must be less than or
equal to the right margin.