TallyGenicom 6605, User Manual

Page: 40 / 212

40
Chapter 3
Integrated Print Management System
Changing Ribbon Cartridge
Before changing the ribbon cartridge, determine whether at the end of ribbon
life, you want to make the print lighter (extend the ribbon life) or darker
(shorten the ribbon life). If you want to make the print lighter or darker, go to
“Ribbon End Point” on page 57 and follow the procedures for adjusting the
image density. If you are satisfied with the print darkness, continue with the
following steps.
NOTE: Ribbon cartridge instructions and illustrations shown in the following
section are for the pedestal model. Follow the same procedures for
the cabinet model.
Figure 20. Preparing to Load the Ribbon
1. Open the printer cover.
2. Raise the platen lever as far as it will go.
3. Ensure the tractor doors are closed.
4. Remove the old ribbon cartridge and discard properly.
TO
F
TO
F
183816a
Blue Tractor
Door (2)
Platen Lever