TallyGenicom 6605, User Manual

Page: 127 / 212

Fault Messages
127
CRTG NOT SETx
Re-install RBN Yes The ribbon cartridge is
not properly positioned. 1. Make sure a ribbon cartridge is
installed in the printer.
2.
Make sure the ribbon cartridge
is seated properly.
3.
Remove and replace the
cartridge if necessary.
4.
Contact your authorized
customer service
representative.
1
CTL VOLT FAIL* No Controller Voltage
Failure. 15 V failure on
the controller board. Contact your authorized service
representative.
1
D50 Status %XX
Clearing Flash
No Status message: The
printer is clearing its flash
memory, where %XX
represents the
percentage completed. No action is required.
D51 Status %XX
Programming...
No Status message: The
printer is loading
firmware, where %XX
represents the
percentage completed. No action is required.
D55 Status: Send
Program to EC No Status message: The
printer is loading the
engine controller program
into the engine controller
(EC). No action is required.
DIAGNOSTIC
PASSED No Status message: the
printer passed its
memory and hardware
initialization tests. No action is required.
DO NOT POWER OFF No Status message: The
printer is performing an
operation that must be
completed before you
can cycle power. No action is required, but do not
power off the printer until the
operation is complete.
DP FIFO Busy* Yes There is a timing problem
in the Engine Controller
firmware. 1. Cycle power. Run the print job
again. If the message appears,
download the emulation
software again.
2.
Cycle power. Run the print job
again. If the message appears
again, contact your authorized
service representative.
1
Table 8. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution