TallyGenicom 6605, User Manual

Page: 123 / 212

Fault Messages
123
Table 8. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution
48V CIRCUIT*
See User Manual
No Either the power supply is
not generating a proper
48 Volts or the controller
board is not detecting a
48 Volt output from the
power supply board. Contact your authorized service
representative.
1
48V PWR FAIL* No Internal power failure. Contact your authorized service
representative.
1
A TO D OVERUN* No Analog to Digital
Overrun. The analog-to-
digital converter
overflowed. Contact your authorized service
representative.
1
ACCESS NULL PTR* No Access Null Pointer: The
processor tried to access
a pointer that contains
nothing (null). Contact your authorized service
representative.
1
B00 STATUS: SDRAM
DETECTION 166MHZ No Status message: the
printer has begun its
boot-up routines and is
checking for the
presence of SDRAM. No action required.
B01 STATUS: 8245
SDRAM TEST 32MB
No Status message: printer
boot-up routines are
testing SDRAM. No action required.
B10 ERROR: NO
DRAM DETECTED* No SDRAM DIMM may not
be properly installed.
Boot-up routines did not
detect the presence of
the SDRAM DIMM. Cycle power to see if the message
clears, if not, contact your
authorized service representative.
1
B11 ERROR: RAM
TEST FAILED* No SDRAM failed the boot
initialization test. SDRAM
DIMM may not be
properly installed. Cycle power to see if the message
clears, if not, contact your
authorized service representative.
1
B12 ERROR:
PROGRAM MISSING* Yes The printer does not see
a program in flash
memory. There is no program in printer
memory. Download an emulation.
B13 ERROR: NOT
COMPATIBLE* No Attempting to download a
program that is not
compatible with the
printer. Cycle power to see if the message
clears, if not, contact your
authorized service representative.
1